FANDOM


Mega Hurts 2
This article is in need of additional or higher-quality images.
The editor who added this tag suggests: {{{1}}}
If you have a good image for this article,
please upload it at Special:Upload
"The actual design is based on the classic world war one tank. This will allow it to continue operation after being tipped over, reducing the advantage wedge type robots have. The only problem is the tracks which require lot of power that is controlled well enough not to cause them to slip off the runners."
— The Beezlebub website on the robot's design.

Beelzebub (pronounced as "Be-el-ze-bub") was a robot which attempted to enter for Series 3 of Robot Wars. However, it failed to qualify for currently unknown reasons.

The robot's name presumably derives from the Semitic Demon of the same name, better known as "The Devil".

DesignEdit

Beezlebub was an invertible, tracked robot with a design based on that of a World War One tank. It was armoured in 2mm steel and built around a steel subframe, and intended to be driven by angle grinder gearboxes which would allow it to reach a hypothetical top speed of 15mph with a 1:2.5 gear ratio. It is unknown what weapons Beezlebub was planned to be equipped with.

Series RecordEdit

Series Beelzebub Series Record
The First Wars Did not enter
The Second Wars Did not enter
The Third Wars Failed to qualify
The Fourth Wars Did not enter
The Fifth Wars Did not enter
The Sixth Wars Did not enter
The Seventh Wars Did not enter
Series 8 Did not enter
Series 9 Did not enter
Series 10 Did not enter

TriviaEdit

  • Beelzebub is the first of two robots that attempted to qualify for Robot Wars to have a name based on the Christian Devil, the other being Luzifer.

External LinksEdit

Build diary from the archived Beezlebub website

Community content is available under CC-BY-SA unless otherwise noted.