Robot Wars Wiki

Editing

Unibite

1
  • The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit. If you are undoing an edit that is …
Latest revision Your text
Line 23: Line 23:
   
 
==Design==
 
==Design==
[[File:Unibite_team_member.jpg|thumb|left|Jerome Miles with Unibite]]
+
<gallery type = "slideshow" position = "left" widths = "240">
  +
Unibite_team_member.jpg|Jerome Miles with Unibite
  +
Unibite2.jpg|Unibite 2.0 in the arena during US Season 2
  +
</gallery>
 
The original Unibite was an invertible, two-wheel drive robot with a wide, low-profile chassis. Its weapon was a front-mounted horizontal spinning disc lined with several cutting teeth, which it used to cause considerable amounts of damage to opponents. The rear of the robot also featured a sign reading 'DEAD', which was made from an old 'DEAD END' road sign.
 
The original Unibite was an invertible, two-wheel drive robot with a wide, low-profile chassis. Its weapon was a front-mounted horizontal spinning disc lined with several cutting teeth, which it used to cause considerable amounts of damage to opponents. The rear of the robot also featured a sign reading 'DEAD', which was made from an old 'DEAD END' road sign.
   
[[File:Unibite2.jpg|thumb|Unibite 2.0 in the arena during US Season 2]]
 
 
In Season 2, the robot was updated to become '''Unibite 2.0''', featuring revised armor, a more conventional two-toothed horizontal flywheel and a set of rear flipping forks. The flywheel had a 29-inch diameter and could rotate at a speed of over 200mph (172mph according to [[Stefan Frank]]).
 
In Season 2, the robot was updated to become '''Unibite 2.0''', featuring revised armor, a more conventional two-toothed horizontal flywheel and a set of rear flipping forks. The flywheel had a 29-inch diameter and could rotate at a speed of over 200mph (172mph according to [[Stefan Frank]]).
   
  Loading editor
Below are some commonly used wiki markup codes. Simply click on what you want to use and it will appear in the edit box above.

View this template